Starter Kit Quick Start Guide

ManualsBrandsRenesas ManualsComputer Hardware7542

Renesas Starter Kit for 7542

Quick Start

LCD module

E8a header

Reset switch

Application Board Interface

LCD module

connector

User LEDs

Analog adjust

User switches

Application Board Interface

E8a emulator

Voltage Conversion Board

(for QzROM microcontroller)

D007294_11_S01_V03

Summary of content (4 pages)

PAGE 1
Quick Start Renesas Starter Kit for 7542 LCD module E8a header Application Board Interface Reset switch LCD module connector Application Board Interface E8a emulator User LEDs Analog adjust User switches Voltage Conversion Board (for QzROM microcontroller) D007294_11_S01_V03
PAGE 2
1. Installation Do not connect the E8a emulator hardware until the software support has been installed. 1. Insert the CD into your computer’s CD-ROM drive. The CD should automatically run the installation program. If the installer does not start, browse to the CD root folder and double click on “setup.exe”. 2. The installer will ask you which language is to be used, please choose the appropriate one. 3. On the first screen of the installer proper, click . 4.
PAGE 3
25. On the Project Generator Information window: Click . The project that is created has two configurations. The Release configuration can be used for the final release code version. The Debug configuration allows modifications to the configuration for debugging. 26. Select the Debug build configuration in the left hand drop down list on the toolbar. 27. Click on the “Build” icon to compile, assemble and link the project. 4. Programming and Debug 28.
PAGE 4
35. Right click on the download module listed in the left hand pane and select “Download”. The code will be downloaded to the microcontroller. This may take several seconds. 36. Click the button. The code will run and you will see the LEDs flash on the board. 37. Click the button. The code will stop and the source code will be opened at the current program counter. 5.