Datasheet

Section 13 8-Bit Timer (TMR)
Rev. 3.00 Sep. 28, 2009 Page 375 of 910
REJ09B0350-0300
13.5 Operation Timing
13.5.1 TCNT Count Timing
Figure 13.4 shows the TCNT count timing with an internal clock source. Figure 13.5 shows the
TCNT count timing with an external clock source. The pulse width of the external clock signal
must be at least 1.5 system clocks (φ) for a single edge and at least 2.5 system clocks (φ) for both
edges. The counter will not increment correctly if the pulse width is less than these values.
φ
Internal clock
TCNT input
clock
TCNT N – 1 N N + 1
Figure 13.4 Count Timing for Internal Clock Input
φ
External clock
input pin
TCNT input
clock
TCNT N – 1 N N + 1
Figure 13.5 Count Timing for External Clock Input (Both Edges)