Datasheet

Section 6 Bus Controller
Rev. 4.00 Sep 27, 2006 page 173 of 1130
REJ09B0327-0400
6.5 Burst ROM Interface
6.5.1 Overview
With this LSI, external space area 0 can be designated as burst ROM space, and burst ROM
interfacing can be performed.
External space can be designated as burst ROM space by means of the BRSTRM bit in BCR.
Consecutive burst accesses of a maximum of 4 words or 8 words can be performed for CPU
instruction fetches only. One or two states can be selected for burst access.
6.5.2 Basic Timing
The number of states in the initial cycle (full access) of the burst ROM interface is in accordance
with the setting of the AST bit. Also, when the AST bit is set to 1, wait state insertion is possible.
One or two states can be selected for the burst cycle, according to the setting of the BRSTS1 bit in
BCR. Wait states cannot be inserted.
When the BRSTS0 bit in BCR is cleared to 0, burst access of up to 4 words is performed; when
the BRSTS0 bit is set to 1, burst access of up to 8 words is performed.
The basic access timing for burst ROM space is shown in figures 6.14 (a) and (b). The timing
shown in figure 6.14 (a) is for the case where the AST and BRSTS1 bits are both set to 1, and that
in figure 6.14 (b) is for the case where both these bits are cleared to 0.