Datasheet

Rev.7.00 Feb. 14, 2007 page xi of xxxii
REJ09B0089-0700
Item Page Revision (See Manual for Details)
17.24.2 User
Program Mode
729 Programming Procedure in User Program Mode:
Description amended
(g) Initialization
• The general registers other than ER0 and ER1 are saved in
the initialization program.
730 (l) Programming
• The general registers other than ER0 and ER1 are saved in
the programming program.
17.25 Protection 738 Description amended
There are three kinds of flash memory program/erase
protection: hardware, software protection, and error protection.
Status
Description amended
(2) Inquiry/Selection State
... required for erasure to the on-chip RAM and erases ...
17.29.1 Serial
Communication
Interface
Specification for Boot
Mode
754
(3) Programming/erasing state
... the programming/erasing programs to the on-chip RAM by
commands ...
759 Inquiry and Selection States
Description amended
(2) Device Selection
• Size (1 byte): Amount of device-code data
This is fixed to 4
760 (3) Clock Mode Inquiry
(Before)
Response H'31 Siz A number of modese Mode SUM
(After)
Response H'31 Size Mode SUM
• Size (1 byte): Amount of data that represents the modes
• Mode (1 byte): Values of the supported ...