Datasheet

Section 5 Interrupt Controller
Rev.7.00 Feb. 14, 2007 page 113 of 1108
REJ09B0089-0700
5.2.2 Interrupt Priority Registers A to K (IPRA to IPRK)
Bit : 7 6 5 4 3 2 1 0
— IPR6 IPR5 IPR4 — IPR2 IPR1 IPR0
Initial value : 0 1 1 1 0 1 1 1
R/W : — R/W R/W R/W — R/W R/W R/W
The IPR registers are eleven 8-bit readable/writable registers that set priorities (levels 7 to 0) for
interrupts other than NMI.
The correspondence between IPR settings and interrupt sources is shown in table 5.3.
The IPR registers set a priority (levels 7 to 0) for each interrupt source other than NMI.
The IPR registers are initialized to H'77 by a reset and in hardware standby mode.
Bits 7 and 3—Reserved: Read-only bits, always read as 0.
Table 5.3 Correspondence between Interrupt Sources and IPR Settings
Bits
Register 6 to 4 2 to 0
IPRA IRQ0 IRQ1
IPRB IRQ2
IRQ3
IRQ4
IRQ5
IPRC IRQ6
IRQ7
DTC
IPRD Watchdog timer —
*
IPRE —
*
A/D converter
IPRF TPU channel 0 TPU channel 1
IPRG TPU channel 2 TPU channel 3
IPRH TPU channel 4 TPU channel 5
IPRI 8-bit timer channel 0 8-bit timer channel 1
IPRJ —
*
SCI channel 0
IPRK SCI channel 1 —
*
Note: * Reserved bits.