Datasheet

Section 6 Bus Controller
Rev.7.00 Feb. 14, 2007 page 150 of 1108
REJ09B0089-0700
Bit 3—Burst Cycle Select 0 (BRSTS0): Selects the number of words that can be accessed in a
burst ROM interface burst access.
Bit 3
BRSTS0 Description
0 Max. 4 words in burst access (Initial value)
1 Max. 8 words in burst access
Bits 2 to 0—Reserved: Only 0 should be written to these bits.
6.2.5 Bus Control Register L (BCRL)
Bit : 7 6 5 4 3 2 1 0
BRLE BREQOE EAE — — — — WAITE
Initial value : 0 0 1 1 1 1 0 0
R/W : R/W R/W R/W R/W R/W R/W R/W R/W
BCRL is an 8-bit readable/writable register that performs selection of the external bus-released
state protocol, selection of the area division unit, and enabling or disabling of WAIT pin input.
BCRL is initialized to H'3C by a reset and in hardware standby mode. It is not initialized in
software standby mode.
Bit 7—Bus Release Enable (BRLE): Enables or disables external bus release.
Bit 7
BRLE Description
0 External bus release is disabled. BREQ, BACK, and BREQO pins can be used as I/O
ports (Initial value)
1 External bus release is enabled