Datasheet

Section 8 I/O Ports
Rev.7.00 Feb. 14, 2007 page 285 of 1108
REJ09B0089-0700
Port F Data Register (PFDR)
Bit : 7 6 5 4 3 2 1 0
PF7DR PF6DR PF5DR PF4DR PF3DR PF2DR PF1DR PF0DR
Initial value : 0 0 0 0 0 0 0 0
R/W : R/W R/W R/W R/W R/W R/W R/W R/W
PFDR is an 8-bit readable/writable register that stores output data for the port F pins (PF7 to PF0).
PFDR is initialized to H'00 by a reset, and in hardware standby mode. It retains its prior state in
software standby mode.
Port F Register (PORTF)
Bit : 7 6 5 4 3 2 1 0
PF7 PF6 PF5 PF4 PF3 PF2 PF1 PF0
Initial value : —
*
—
*
—
*
—
*
—
*
—
*
—
*
—
*
R/W : R R R R R R R R
Note: * Determined by state of pins PF7 to PF0.
PORTF is an 8-bit read-only register that shows the pin states, and cannot be modified. Writing of
output data for the port F pins (PF7 to PF0) must always be performed on PFDR.
If a port F read is performed while PFDDR bits are set to 1, the PFDR values are read. If a port F
read is performed while PFDDR bits are cleared to 0, the pin states are read.
After a reset and in hardware standby mode, PORTF contents are determined by the pin states, as
PFDDR and PFDR are initialized. PORTF retains its prior state in software standby mode.
Port Function Control Register 1 (PFCR1)
Bit : 7 6 5 4 3 2 1 0
CSS17 CSS36 PF1CS5S PF0CS4S A23E A22E A21E A20E
Initial value : 0 0 0 0 1 1 1 1
R/W : R/W R/W R/W R/W R/W R/W R/W R/W
PFCR1 is an 8-bit readable/writable register that performs I/O port control. PFCR1 is initialized to
H'0F by a reset, and in hardware standby mode.