Datasheet

Section 17 ROM
Rev.7.00 Feb. 14, 2007 page 669 of 1108
REJ09B0089-0700
17.20 Flash Memory Programmer Mode
17.20.1 Programmer Mode Setting
Programs and data can be written and erased in programmer mode as well as in the on-board
programming modes. In programmer mode, the on-chip ROM can be freely programmed using a
PROM programmer that supports the Renesas Technology microcomputer device type with 512-
kbyte on-chip flash memory (FZTAT512V3A). Flash memory read mode, auto-program mode,
auto-erase mode, and status read mode are supported with this device type. In auto-program
mode, auto-erase mode, and status read mode, a status polling procedure is used, and in status read
mode, detailed internal signals are output after execution of an auto-program or auto-erase
operation.
Table 17.34 shows programmer mode pin settings.
Table 17.34 Programmer Mode Pin Settings
Pin Names Settings/External Circuit Connection
Mode pins: MD2, MD1, MD0 Low-level input
Mode setting pins: PF2, PF1, PF0 High-level input to PF2, low-level input to PF1 and PF0
STBY pin High-level input (do not select hardware standby mode)
RES pin Reset circuit
XTAL, EXTAL pins Oscillator circuit
Other pins requiring setting: P23, P25 High-level input to P23, low-level input to P25