Datasheet

Section 17 ROM
Rev.7.00 Feb. 14, 2007 page 673 of 1108
REJ09B0089-0700
Table 17.36 Programmer Mode Commands
1st Cycle 2nd Cycle
Command Name
Number
of Cycles Mode Address Data Mode Address Data
Memory read mode 1 + n Write × H'00 Read RA Dout
Auto-program mode 129 Write × H'40 Write PA Din
Auto-erase mode 2 Write × H'20 Write × H'20
Status read mode 2 Write × H'71 Write × H'71
Legend:
RA: Read address
PA: Program address
×: Don’t care
Notes: 1. In auto-program mode, 129 cycles are required for command writing by a simultaneous
128-byte write.
2. In memory read mode, the number of cycles depends on the number of address write
cycles (n).
17.20.4 Memory Read Mode
• After the end of an auto-program, auto-erase, or status read operation, the command wait state
is entered. To read memory contents, a transition must be made to memory read mode by
means of a command write before the read is executed.
• Command writes can be performed in memory read mode, just as in the command wait state.
• Once memory read mode has been entered, consecutive reads can be performed.
• After power-on, memory read mode is entered.