Datasheet

Section 19 Power-Down Modes
Rev.7.00 Feb. 14, 2007 page 806 of 1108
REJ09B0089-0700
• The division ratio can be changed while the chip is operating. The clock output from the φ pin
will also change when the division ratio is changed. The frequency of the clock output from
the φ pin in this case will be as follows:
φ = EXTAL × n
Where: EXTAL: Crystal resonator or external clock frequency
n: Division ratio (n = φ/2, φ/4, or φ/8)
• Do not set the DIV bit and bits SCK2 to SCK0 simultaneously. First set the DIV bit, then bits
SCK2 to SCK0.
Bit 5
DIV Description
0 When bits SCK2 to SCK0 are set to other than high-speed mode, medium-speed
mode is set (Initial value)
1 When bits SCK2 to SCK0 are set to other than high-speed mode, a divided clock is
supplied to the entire chip
Bits 4 and 3—Reserved: These bits cannot be modified and are always read as 0.
Bits 2 to 0—System Clock Select 2 to 0 (SCK2 to SCK0): When the DIV bit is cleared to 0,
these bits select the bus master clock; when the DIV bit is set to 1, they select the division ratio of
the clock supplied to the entire chip.
Description
Bit 2
SCK2
Bit 1
SCK1
Bit 0
SCK0 DIV = 0 DIV = 1
0 0 0 Bus master is in high-speed
mode (Initial value)
Bus master is in high-speed
mode (Initial value)
1 Medium-speed clock is φ/2 Clock supplied to entire chip is φ/2
1 0 Medium-speed clock is φ/4 Clock supplied to entire chip is φ/4
1 Medium-speed clock is φ/8 Clock supplied to entire chip is φ/8
1 0 0 Medium-speed clock is φ/16 —
1 Medium-speed clock is φ/32 —
1 — — —