Datasheet

Section 9 16-Bit Timer Pulse Unit (TPU)
Rev.7.00 Feb. 14, 2007 page 334 of 1108
REJ09B0089-0700
Bit 6—Reserved: This bit cannot be modified and is always read as 1.
Bit 5—Underflow Flag (TCFU): Status flag that indicates that TCNT underflow has occurred
when channels 1, 2, 4, and 5 are set to phase counting mode.
In channels 0 and 3, bit 5 is reserved. It is always read as 0 and cannot be modified.
Bit 5
TCFU Description
0 [Clearing condition] (Initial value)
When 0 is written to TCFU after reading TCFU = 1
1 [Setting condition]
When the TCNT value underflows (changes from H'0000 to H'FFFF)
Bit 4—Overflow Flag (TCFV): Status flag that indicates that TCNT overflow has occurred.
Bit 4
TCFV Description
0 [Clearing condition] (Initial value)
When 0 is written to TCFV after reading TCFV = 1
1 [Setting condition]
When the TCNT value overflows (changes from H'FFFF to H'0000 )
Bit 3—Input Capture/Output Compare Flag D (TGFD): Status flag that indicates the
occurrence of TGRD input capture or compare match in channels 0 and 3.
In channels 1, 2, 4, and 5, bit 3 is reserved. It is always read as 0 and cannot be modified.
Bit 3
TGFD Description
0 [Clearing conditions] (Initial value)
• When DTC is activated by TGID interrupt while DISEL bit of MRB in DTC is 0
• When 0 is written to TGFD after reading TGFD = 1
1 [Setting conditions]
• When TCNT = TGRD while TGRD is functioning as output compare register
• When TCNT value is transferred to TGRD by input capture signal while TGRD is
functioning as input capture register