Datasheet

Section 5 Interrupt Controller
Rev.7.00 Mar. 18, 2009 page 106 of 1136
REJ09B0109-0700
5.3.1 Interrupt Control Register (INTCR)
INTCR selects the interrupt control mode, and the detected edge for NMI.
Bit Bit Name Initial Value R/W Description
7, 6 — All 0 — Reserved
These bits are always read as 0 and the initial value
should not be changed.
5
4
INTM1
INTM0
0
0
R/W
R/W
Interrupt Control Select Mode 1 and 0
These bits select either of two interrupt control modes
for the interrupt controller.
00: Interrupt control mode 0
Interrupts are controlled by I bit.
01: Setting prohibited.
10: Interrupt control mode 2
Interrupts are controlled by bits I2 to I0, and IPR.
11: Setting prohibited.
3 NMIEG 0 R/W NMI Edge Select
Selects the input edge for the NMI pin.
0: Interrupt request generated at falling edge of NMI
input
1: Interrupt request generated at rising edge of NMI
input
2 to
0
— All 0 — Reserved
These bits are always read as 0 and the initial value
should not be changed.
5.3.2 Interrupt Priority Registers A to K (IPRA to IPRK)
IPR are eleven 16-bit readable/writable registers that set priorities (levels 7 to 0) for interrupts
other than NMI.
The correspondence between interrupt sources and IPR settings is shown in table 5.2 (Interrupt
Sources, Vector Addresses, and Interrupt Priorities). Setting a value in the range from H'0 to H'7
in the 3-bit groups of bits 14 to 12, 10 to 8, 6 to 4, and 2 to 0 sets the priority of the corresponding
interrupt. IPR should be read in word size.