Datasheet

Section 8 EXDMA Controller (EXDMAC)
Rev.7.00 Mar. 18, 2009 page 368 of 1136
REJ09B0109-0700
Bit Bit Name Initial Value R/W Description
6 IRF 0 R/(W)
*
Interrupt Request Flag
Flag indicating that an interrupt request has
occurred and transfer has ended.
0: No interrupt request
[Clearing conditions]
• Writing 1 to the EDA bit
• Writing 0 to IRF after reading IRF = 1
1: Interrupt request occurrence
[Setting conditions]
• Transfer end interrupt request generated by
transfer counter
• Source address repeat area overflow interrupt
request
• Destination address repeat area overflow
interrupt request
5 TCEIE 0 R/W Transfer Counter End Interrupt Enable
Enables or disables transfer end interrupt
requests by the transfer counter. When
transfer ends according to the transfer counter
while this bit is set to 1, the IRF bit is set to 1,
indicating that an interrupt request has
occurred.
0: Transfer end interrupt requests by transfer
counter are disabled
1: Transfer end interrupt requests by transfer
counter are enabled
4 SDIR 0 R/W Single Address Direction
Specifies the data transfer direction in single
address mode. In dual address mode, the
specification by this bit is ignored.
0: Transfer direction: EDSAR → external
device with DACK
1: Transfer direction: External device with
DACK→ EDDAR