Datasheet

Section 8 EXDMA Controller (EXDMAC)
Rev.7.00 Mar. 18, 2009 page 404 of 1136
REJ09B0109-0700
EDREQ Pin Low Level Activation Timing: Figure 8.27 shows an example of single address
mode transfer activated by the EDREQ pin low level.
Single Single
DMA single
Address bus
φ
EDREQ
Idle
Bus release
DMA control
Channel
Transfer source/
destination
Transfer source/
destination
Bus release
Idle
DMA single
Bus release
Idle
EDACK
[1] [3][2] [4] [6][5] [7]
Acceptance
resumed
Acceptance
resumed
Request
clearance period
Request
clearance period
Request Request
Minimum 3 cycles Minimum 3 cycles
[1] Acceptance after transfer enabling; EDREQ pin low level is sampled at rise of φ, and request is held.
[2], [5] Request is cleared at end of next bus cycle, and activation is started in EXDMAC.
[3], [6] DMA cycle is started.
[4], [7] Acceptance is resumed after completion of single cycle.
(As in [1], EDREQ pin low level is sampled at rise of φ, and request is held.)
Figure 8.27 Example of Single Address Mode Transfer Activated by EDREQ Pin Low Level
EDREQ pin sampling is performed in each cycle starting at the next rise of φ after the end of the
EDMDR write cycle for setting the transfer-enabled state.
When a low level is sampled at the EDREQ pin while acceptance via the EDREQ pin is possible,
the request is held within the EXDMAC. Then when activation is initiated within the EXDMAC,
the request is cleared. At the end of the single cycle, acceptance resumes and EDREQ pin low
level sampling is performed again; this sequence of operations is repeated until the end of the
transfer.