Datasheet

Section 18 D/A Converter
Rev.7.00 Mar. 18, 2009 page 830 of 1136
REJ09B0109-0700
Conversion data 1
Conversion
result 1
High-impedance state
t
DCONV
DADR2
write cycle
DA2
DAOE2
DADR2
A
ddress
φ
DACR23
write cycle
Conversion data 2
Conversion
result 2
t
DCONV
Legend:
t
DCONV
: D/A conversion time
DADR2
write cycle
DACR23
write cycle
Figure 18.3 Example of D/A Converter Operation
18.5 Usage Notes
18.5.1 Setting for Module Stop Mode
It is possible to enable/disable the D/A converter operation using the module stop control register,
the D/A converter does not operate by the initial value of the register. The register can be accessed
by releasing the module stop mode. For details, see section 24, Power-Down Modes.
18.5.2 D/A Output Hold Function in Software Standby Mode
If D/A conversion is enabled and this LSI enters software standby mode, D/A output is held and
analog power supply current remains at the same level during D/A conversion. When the analog
power supply current is required to go low in software standby mode, bits DAOE and DAE should
be cleared to 0, and D/A output should be disabled.