Datasheet

Section 22 ROM
Page 952 of 1434 R01UH0166EJ0600 Rev. 6.00
Mar 02, 2011
H8S/2633 Group, H8S/2633 F-ZTAT
TM
,
H8S/2633R F-ZTAT
TM
, H8S/2695
22.5 Register Descriptions
22.5.1 Flash Memory Control Register 1 (FLMCR1)
Bit: 7 6 5 4 3 2 1 0
FWE SWE1 ESU1 PSU1 EV1 PV1 E1 P1
Initial value: —
*
0 0 0 0 0 0 0
R/W: R R/W R/W R/W R/W R/W R/W R/W
Note: * Determined by the state of the FWE pin.
FLMCR1 is an 8-bit register used for flash memory operating mode control. Program-verify mode
or erase-verify mode for addresses H'00000 to H'3FFFF is entered by setting SWE1 bit to 1 when
FWE = 1, then setting the PV1 or EV1 bit. Program mode for addresses H'00000 to H'3FFFF is
entered by setting SWE1 bit to 1 when FWE = 1, then setting the PSU1 bit, and finally setting the
P1 bit. Erase mode for addresses H'00000 to H'3FFFF is entered by setting SWE1 bit to 1 when
FWE = 1, then setting the ESU1 bit, and finally setting the E1 bit. FLMCR1 is initialized by a
power-on reset, and in hardware standby mode and software standby mode. Its initial value is H'80
when a high level is input to the FWE pin, and H'00 when a low level is input. When on-chip flash
memory is disabled, a read will return H'00, and writes are invalid.
Writes are enabled only in the following cases: Writes to bit SWE1 of FLMCR1 enabled when
FWE = 1, to bits ESU1, PSU1, EV1, and PV1 when FWE = 1 and SWE1 = 1, to bit E1 when
FWE = 1, SWE1 = 1 and ESU1 = 1, and to bit P1 when FWE = 1, SWE1 = 1, and PSU1 = 1.
Bit 7—Flash Write Enable Bit (FWE): Sets hardware protection against flash memory
programming/erasing.
Bit 7
FWE Description
0 When a low level is input to the FWE pin (hardware-protected state)
1 When a high level is input to the FWE pin