Datasheet

Section 5 Interrupt Controller
Page 154 of 1434 R01UH0166EJ0600 Rev. 6.00
Mar 02, 2011
H8S/2633 Group, H8S/2633 F-ZTAT
TM
,
H8S/2633R F-ZTAT
TM
, H8S/2695
5.5.4 Interrupts during Execution of EEPMOV Instruction
Interrupt operation differs between the EEPMOV.B instruction and the EEPMOV.W instruction.
With the EEPMOV.B instruction, an interrupt request (including NMI) issued during the transfer
is not accepted until the move is completed.
With the EEPMOV.W instruction, if an interrupt request is issued during the transfer, interrupt
exception handling starts at a break in the transfer cycle. The PC value saved on the stack in this
case is the address of the next instruction.
Therefore, if an interrupt is generated during execution of an EEPMOV.W instruction, the
following coding should be used.
L1: EEPMOV.W
MOV.W R4,R4
BNE L1
5.5.5 IRQ Interrupt
When operating by clock input, acceptance of input to an IRQ is synchronized with the clock. In
software standby mode, the input is accepted asynchronously. For details on the input conditions,
see section 25.3.2, Control Signal Timing.
5.5.6 NMI Interrupt Usage Notes
The NMI interrupt is part of the exception processing performed cooperatively by the LSI’s
internal interrupt controller and the CPU when the system is operating normally under the
specified electrical conditions. No operations, including NMI interrupts, are guaranteed when
operation is not normal (runaway status) due to software problems or abnormal input to the LSI’s
pins. In such cases, the LSI may be restored to the normal program execution state by applying an
external reset.