Datasheet

Section 7 Bus Controller
R01UH0166EJ0600 Rev. 6.00 Page 195 of 1434
Mar 02, 2011
H8S/2633 Group, H8S/2633 F-ZTAT
TM
,
H8S/2633R F-ZTAT
TM
, H8S/2695
7.3.2 Bus Specifications
The external space bus specifications consist of three elements: bus width, number of access
states, and number of program wait states.
The bus width and number of access states for on-chip memory and internal I/O registers are
fixed, and are not affected by the bus controller.
(1) Bus Width: A bus width of 8 or 16 bits can be selected with ABWCR. An area for which an
8-bit bus is selected functions as an 8-bit access space, and an area for which a 16-bit bus is
selected functions as a16-bit access space.
If all areas are designated for 8-bit access, 8-bit bus mode is set; if any area is designated for 16-
bit access, 16-bit bus mode is set. When the burst ROM interface is designated, 16-bit bus mode is
always set.
(2) Number of Access States: Two or three access states can be selected with ASTCR. An area
for which 2-state access is selected functions as a 2-state access space, and an area for which 3-
state access is selected functions as a 3-state access space.
With the DRAM interface
*
or the burst ROM interface, the number of access states may be
determined without regard to ASTCR.
When 2-state access space is designated, wait insertion is disabled.
Note: * This function is not available in the H8S/2695.
(3) Number of Program Wait States: When 3-state access space is designated by ASTCR, the
number of program wait states to be inserted automatically is selected with WCRH and WCRL.
From 0 to 3 program wait states can be selected.
Table 7.3 shows the bus specifications for each basic bus interface area.