Datasheet

Section 8 DMA Controller (DMAC)
(This function is not available in the H8S/2695)
R01UH0166EJ0600 Rev. 6.00 Page 291 of 1434
Mar 02, 2011
H8S/2633 Group, H8S/2633 F-ZTAT
TM
,
H8S/2633R F-ZTAT
TM
, H8S/2695
Figure 8.5 illustrates operation in idle mode.
Transfer
IOAR
1 byte or word transfer performed in
response to 1 transfer request
MAR
Figure 8.5 Operation in Idle Mode
The number of transfers is specified as 16 bits in ETCR. ETCR is decremented by 1 each time a
transfer is executed, and when its value reaches H'0000, the DTE bit is cleared and transfer ends.
If the DTIE bit is set to 1 at this time, an interrupt request is sent to the CPU or DTC.
The maximum number of transfers, when H'0000 is set in ETCR, is 65,536.
Transfer requests (activation sources) consist of A/D converter conversion end interrupts, external
requests, SCI transmission complete and reception complete interrupts, and TPU channels 0 to 5
compare match/input capture A interrupts. External requests can be set for channel B only.
When the DMAC is used in single address mode, only channel B can be set.