Datasheet

Section 8 DMA Controller (DMAC)
(This function is not available in the H8S/2695)
R01UH0166EJ0600 Rev. 6.00 Page 297 of 1434
Mar 02, 2011
H8S/2633 Group, H8S/2633 F-ZTAT
TM
,
H8S/2633R F-ZTAT
TM
, H8S/2695
8.5.5 Single Address Mode
Single address mode can only be specified for channel B. This mode can be specified by setting
the SAE bit in DMABCR to 1 in short address mode.
One address is specified by MAR, and the other is set automatically to the data transfer
acknowledge pin (DACK). The transfer direction can be specified by the DTDIR in DMACR.
Table 8.9 summarizes register functions in single address mode.
Table 8.9 Register Functions in Single Address Mode
Function
Register DTDIR = 0 DTDIR = 1 Initial Setting Operation
23 0
MAR
Source
address
register
Destination
address
register
Start address of
transfer destination or
transfer source
*
DACK pin Write
strobe
Read
strobe
(Set automatically by
SAE bit; IOAR is
invalid)
Strobe for external
device
015
ETCR
Transfer counter Number of transfers *
Legend:
MAR: Memory address register
IOAR: I/O address register
ETCR: Transfer count register
DTDIR: Data transfer direction bit
DACK: Data transfer acknowledge
Note: * See the operation descriptions in sections 8.5.2, Sequential Mode, 8.5.3, Idle Mode, and
8.5.4, Repeat Mode.
MAR specifies the start address of the transfer source or transfer destination as 24 bits.
IOAR is invalid; in its place the strobe for external devices (DACK) is output.