Datasheet

Section 8 DMA Controller (DMAC)
(This function is not available in the H8S/2695)
R01UH0166EJ0600 Rev. 6.00 Page 325 of 1434
Mar 02, 2011
H8S/2633 Group, H8S/2633 F-ZTAT
TM
,
H8S/2633R F-ZTAT
TM
, H8S/2695
DREQ Pin Falling Edge Activation Timing: Set the DTA bit for the channel for which the
DREQ pin is selected to 1.
Figure 8.31 shows an example of DREQ pin falling edge activated single address mode transfer.
φ
DREQ
Bus release DMA single DMA single
Address bus
DMA control
Channel
[2]
DACK
Transfer source/
destination
Idle Idle IdleSingleSingle
[1] [3] [5][4] [6] [7]
Acceptance resumesAcceptance resumes
Bus release Bus release
Transfer source/
destination
Request Request
Minimum of
2 cycles
Minimum of
2 cycles
Request clear
period
Request clear
period
[1]
[2] [5]
[3] [6]
[4] [7]
Acceptance after transfer enabling; the DREQ pin low level is sampled on the rising
edge of φ, and the request is held.
The request is cleared at the next bus break, and activation is started in the DMAC.
Start of DMA cycle; DREQ pin high level sampling on the rising edge of φ starts.
When the DREQ pin high level has been sampled, acceptance is resumed after the single
cycle is completed.
(As in [1], the DREQ pin low level is sampled on the rising edge of φ, and the request is held.)
Note: In write data buffer mode, bus breaks from [2] to [7] may be hidden, and not visible.
Figure 8.31 Example of DREQ Pin Falling Edge Activated Single Address Mode Transfer
DREQ pin sampling is performed every cycle, with the rising edge of the next φ cycle after the
end of the DMABCR write cycle for setting the transfer enabled state as the starting point.
When the DREQ pin low level is sampled while acceptance by means of the DREQ pin is
possible, the request is held in the DMAC. Then, when activation is initiated in the DMAC, the
request is cleared, and DREQ pin high level sampling for edge detection is started. If DREQ pin
high level sampling has been completed by the time the DMA single cycle ends, acceptance
resumes after the end of the single cycle, DREQ pin low level sampling is performed again, and
this operation is repeated until the transfer ends.