Datasheet

Section 8 DMA Controller (DMAC)
(This function is not available in the H8S/2695)
R01UH0166EJ0600 Rev. 6.00 Page 331 of 1434
Mar 02, 2011
H8S/2633 Group, H8S/2633 F-ZTAT
TM
,
H8S/2633R F-ZTAT
TM
, H8S/2695
8.5.16 Forced Termination of DMAC Operation
If the DTE bit for the channel currently operating is cleared to 0, the DMAC stops on completion
of the 1-byte or 1-word transfer in progress. DMAC operation resumes when the DTE bit is set to
1 again.
In full address mode, the same applies to the DTME bit.
Figure 8.37 shows the procedure for forcibly terminating DMAC operation by software.
Forced termination
of DMAC
Clear DTE bit to 0
Forced termination
[1]
[1] Clear the DTE bit in DMABCRL to 0.
If you want to prevent interrupt generation after
forced termination of DMAC operation, clear the
DTIE bit to 0 at the same time.
Figure 8.37 Example of Procedure for Forcibly Terminating DMAC Operation