Datasheet

Section 9 Data Transfer Controller (DTC)
(This function is not available in the H8S/2695)
Page 344 of 1434 R01UH0166EJ0600 Rev. 6.00
Mar 02, 2011
H8S/2633 Group, H8S/2633 F-ZTAT
TM
,
H8S/2633R F-ZTAT
TM
, H8S/2695
Bit 7—DTC Chain Transfer Enable (CHNE): Specifies chain transfer. With chain transfer, a
number of data transfers can be performed consecutively in response to a single transfer request.
In data transfer with CHNE set to 1, determination of the end of the specified number of transfers,
clearing of the interrupt source flag, and clearing of DTCER is not performed.
Bit 7
CHNE Description
0 End of DTC data transfer (activation waiting state is entered)
1 DTC chain transfer (new register information is read, then data is transferred)
Bit 6—DTC Interrupt Select (DISEL): Specifies whether interrupt requests to the CPU are
disabled or enabled after a data transfer.
Bit 6
DISEL Description
0 After a data transfer ends, the CPU interrupt is disabled unless the transfer counter is
0 (the DTC clears the interrupt source flag of the activating interrupt to 0)
1 After a data transfer ends, the CPU interrupt is enabled (the DTC does not clear the
interrupt source flag of the activating interrupt to 0)
Bits 5 to 0—Reserved: These bits have no effect on DTC operation in the H8S/2633 Group, and
should always be written with 0.
9.2.3 DTC Source Address Register (SAR)
23 22 21 20 19 43210
Bit
Initial value
:
:
—
Unde-
fined
R/W :
—
Unde-
fined
—
Unde-
fined
—
Unde-
fined
—
Unde-
fined
—
Unde-
fined
—
Unde-
fined
—
Unde-
fined
—
Unde-
fined
—
Unde-
fined
SAR is a 24-bit register that designates the source address of data to be transferred by the DTC.
For word-size transfer, specify an even source address.