Datasheet

Section 10B I/O Ports
(H8S/2695)
R01UH0166EJ0600 Rev. 6.00 Page 501 of 1434
Mar 02, 2011
H8S/2633 Group, H8S/2633 F-ZTAT
TM
,
H8S/2633R F-ZTAT
TM
, H8S/2695
10B.7.4 MOS Input Pull-Up Function
Port A has a built-in MOS input pull-up function that can be controlled by software. MOS input
pull-up can be specified as on or off on an individual bit basis.
In modes 4 to 6, if a pin is in the input state in accordance with the settings in PFCR, in the SCI’s
SCMR, SMR, and SCR, and in DDR, setting the corresponding PAPCR bit to 1 turns on the MOS
input pull-up for that pin.
In mode 7, if a pin is in the input state in accordance with the settings in the SCI’s SCMR, SMR,
and SCR, and in DDR, setting the corresponding PAPCR bit to 1 turns on the MOS input pull-up
for that pin.
The MOS input pull-up function is in the off state after a power-on reset, and in hardware standby
mode. The prior state is retained by a manual reset or in software standby mode.
Table 10B.12 summarizes the MOS input pull-up states.
Table 10B.12 MOS Input Pull-Up States (Port A)
Pin States
Power-On
Reset
Hardware
Standby Mode
Manual
Reset
Software
Standby Mode
In Other
Operations
Address output or
SCI output
OFF OFF OFF OFF OFF
Other than above ON/OFF ON/OFF ON/OFF
Legend:
OFF: MOS input pull-up is always off.
ON/OFF: On when PADDR = 0 and PAPCR = 1; otherwise off.