Datasheet

Section 10B I/O Ports
(H8S/2695)
Page 518 of 1434 R01UH0166EJ0600 Rev. 6.00
Mar 02, 2011
H8S/2633 Group, H8S/2633 F-ZTAT
TM
,
H8S/2633R F-ZTAT
TM
, H8S/2695
Port C Data Register (PCDR)
Bit : 7 6 5 4 3 2 1 0
PC7DR PC6DR PC5DR PC4DR PC3DR PC2DR PC1DR PC0DR
Initial value : 0 0 0 0 0 0 0 0
R/W : R/W R/W R/W R/W R/W R/W R/W R/W
PCDR is an 8-bit readable/writable register that stores output data for the port C pins (PC7 to
PC0).
PCDR is initialized to H'00 by a power-on reset, and in hardware standby mode. It retains its prior
state by a manual reset or in software standby mode.
Port C Register (PORTC)
Bit : 7 6 5 4 3 2 1 0
PC7 PC6 PC5 PC4 PC3 PC2 PC1 PC0
Initial value : —
*
—
*
—
*
—
*
—
*
—
*
—
*
—
*
R/W : R R R R R R R R
Note: * Determined by state of pins PC7 to PC0.
PORTC is an 8-bit read-only register that shows the pin states. It cannot be written to. Writing of
output data for the port C pins (PC7 to PC0) must always be performed on PCDR.
If a PORTC read is performed while PCDDR bits are set to 1, the PCDR values are read. If a
PORTC read is performed while PCDDR bits are cleared to 0, the pin states are read.
After a power-on reset and in hardware standby mode, PORTC contents are determined by the pin
states, as PCDDR and PCDR are initialized. PORTC retains its prior state by a manual reset or in
software standby mode.