Datasheet

Section 10B I/O Ports
(H8S/2695)
R01UH0166EJ0600 Rev. 6.00 Page 525 of 1434
Mar 02, 2011
H8S/2633 Group, H8S/2633 F-ZTAT
TM
,
H8S/2633R F-ZTAT
TM
, H8S/2695
Port D Data Register (PDDR)
Bit : 7 6 5 4 3 2 1 0
PD7DR PD6DR PD5DR PD4DR PD3DR PD2DR PD1DR PD0DR
Initial value : 0 0 0 0 0 0 0 0
R/W : R/W R/W R/W R/W R/W R/W R/W R/W
PDDR is an 8-bit readable/writable register that stores output data for the port D pins (PD7 to
PD0).
PDDR is initialized to H'00 by a power-on reset, and in hardware standby mode. It retains its prior
state by a manual reset or in software standby mode.
Port D Register (PORTD)
Bit : 7 6 5 4 3 2 1 0
PD7 PD6 PD5 PD4 PD3 PD2 PD1 PD0
Initial value : —
*
—
*
—
*
—
*
—
*
—
*
—
*
—
*
R/W : R R R R R R R R
Note: * Determined by state of pins PD7 to PD0.
PORTD is an 8-bit read-only register that shows the pin states. It cannot be written to. Writing of
output data for the port D pins (PD7 to PD0) must always be performed on PDDR.
If a PORTD read is performed while PDDDR bits are set to 1, the PDDR values are read. If a
PORTD read is performed while PDDDR bits are cleared to 0, the pin states are read.
After a power-on reset and in hardware standby mode, PORTD contents are determined by the pin
states, as PDDDR and PDDR are initialized. PORTD retains its prior state by a manual reset or in
software standby mode.