Datasheet

Section 11 16-Bit Timer Pulse Unit (TPU)
Page 554 of 1434 R01UH0166EJ0600 Rev. 6.00
Mar 02, 2011
H8S/2633 Group, H8S/2633 F-ZTAT
TM
,
H8S/2633R F-ZTAT
TM
, H8S/2695
Bits 4 and 3—Clock Edge 1 and 0 (CKEG1, CKEG0): These bits select the input clock edge.
When the input clock is counted using both edges, the input clock period is halved (e.g. φ/4 both
edges = φ/2 rising edge). If phase counting mode is used on channels 1, 2, 4, and 5, this setting is
ignored and the phase counting mode setting has priority.
Bit 4 Bit 3
CKEG1 CKEG0 Description
0 0 Count at rising edge (Initial value)
1 Count at falling edge
1 — Count at both edges
Note: Internal clock edge selection is valid when the input clock is φ/4 or slower. This setting is
ignored if the input clock is φ/1, or when overflow/underflow of another channel is selected.
(The clock is counted at the falling edge when φ/1 is selected.)
Bits 2 to 0—Time Prescaler 2 to 0 (TPSC2 to TPSC0): These bits select the TCNT counter
clock. The clock source can be selected independently for each channel. Table 11.4 shows the
clock sources that can be set for each channel.
Table 11.4 TPU Clock Sources
Internal Clock
External Clock
Channel φ/1 φ/4 φ/16 φ/64 φ/256 φ/1024 φ/4096 TCLKA TCLKB TCLKC TCLKD
Overflow/
Underflow
on Another
Channel
0
1
2
3
4
5
Legend:
: Setting
Blank: No setting