Datasheet

Section 12 Programmable Pulse Generator (PPG)
(This function is not available in the H8S/2695)
R01UH0166EJ0600 Rev. 6.00 Page 659 of 1434
Mar 02, 2011
H8S/2633 Group, H8S/2633 F-ZTAT
TM
,
H8S/2633R F-ZTAT
TM
, H8S/2695
12.3.6 Pulse Output Triggered by Input Capture
Pulse output can be triggered by TPU input capture as well as by compare match. If TGRA
functions as an input capture register in the TPU channel selected by PCR, pulse output will be
triggered by the input capture signal.
Figure 12.9 shows the timing of this output.
φ
N
M
N
TIOC pin
Input capture
signal
NDR
PODR
MN
PO
Figure 12.9 Pulse Output Triggered by Input Capture (Example)
12.4 Usage Notes
Operation of Pulse Output Pins: Pins PO8 to PO15 are also used for other peripheral functions
such as the TPU. When output by another peripheral function is enabled, the corresponding pins
cannot be used for pulse output. Note, however, that data transfer from NDR bits to PODR bits
takes place, regardless of the usage of the pins.
Pin functions should be changed only under conditions in which the output trigger event will not
occur.
Note on Non-Overlapping Output: During non-overlapping operation, the transfer of NDR bit
values to PODR bits takes place as follows.
• NDR bits are always transferred to PODR bits at compare match A.
• At compare match B, NDR bits are transferred only if their value is 0. Bits are not transferred
if their value is 1.