Datasheet

Section 16 Serial Communication Interface (SCI, IrDA)
(The H8S/2695 is not equipped with an IrDA function)
R01UH0166EJ0600 Rev. 6.00 Page 791 of 1434
Mar 02, 2011
H8S/2633 Group, H8S/2633 F-ZTAT
TM
,
H8S/2633R F-ZTAT
TM
, H8S/2695
Table 16.13 SCI Interrupt Sources
Channel
Interrupt
Source Description
DTC
*
1
Activation
DMAC
*
1
Activation Priority
*
2
0 ERI Interrupt due to receive error (ORER, FER, or
PER)
Not possible Not possible High
RXI Interrupt due to receive data full state (RDRF) Possible Possible
TXI Interrupt due to transmit data empty state
(TDRE)
Possible Possible
TEI Interrupt due to transmission end (TEND) Not possible Not possible
1 ERI Interrupt due to receive error (ORER, FER, or
PER)
Not possible Not possible
RXI Interrupt due to receive data full state (RDRF) Possible Possible
TXI Interrupt due to transmit data empty state
(TDRE)
Possible Possible
TEI Interrupt due to transmission end (TEND) Not possible Not possible
2 ERI Interrupt due to receive error (ORER, FER, or
PER)
Not possible Not possible
RXI Interrupt due to receive data full state (RDRF) Possible Not possible
TXI Interrupt due to transmit data empty state
(TDRE)
Possible Not possible
TEI Interrupt due to transmission end (TEND) Not possible Not possible
3 ERI Interrupt due to receive error (ORER, FER, or
PER)
Not possible Not possible
RXI Interrupt due to receive data full state (RDRF) Possible Not possible
TXI Interrupt due to transmit data empty state
(TDRE)
Possible Not possible
TEI Interrupt due to transmission end (TEND) Not possible Not possible
4 ERI Interrupt due to receive error (ORER, FER, or
PER)
Not possible Not possible
RXI Interrupt due to receive data full state (RDRF) Possible Not possible
TXI Interrupt due to transmit data empty state
(TDRE)
Possible Not possible
TEI Interrupt due to transmission end (TEND) Not possible Not possible Low
Notes: 1. DMAC and DTC functions are not available in the H8S/2695.
2. This table shows the initial state immediately after a reset. Relative priorities among
channels can be changed by means of the interrupt controller.