Datasheet

Section 17 Smart Card Interface
Page 818 of 1434 R01UH0166EJ0600 Rev. 6.00
Mar 02, 2011
H8S/2633 Group, H8S/2633 F-ZTAT
TM
,
H8S/2633R F-ZTAT
TM
, H8S/2695
17.3.4 Register Settings
Table 17.3 shows a bit map of the registers used by the smart card interface.
Bits indicated as 0 or 1 must be set to the value shown. The setting of other bits is described
below.
Table 17.3 Smart Card Interface Register Settings
Bit
Register Bit 7 Bit 6 Bit 5 Bit 4 Bit 3 Bit 2 Bit 1 Bit 0
SMR GM BLK 1 O/E BCP1 BCP0 CKS1 CKS0
BRR BRR7 BRR6 BRR5 BRR4 BRR3 BRR2 BRR1 BRR0
SCR TIE RIE TE RE 0 0 CKE1
*
CKE0
TDR TDR7 TDR6 TDR5 TDR4 TDR3 TDR2 TDR1 TDR0
SSR TDRE RDRF ORER ERS PER TEND 0 0
RDR RDR7 RDR6 RDR5 RDR4 RDR3 RDR2 RDR1 RDR0
SCMR — — — — SDIR SINV — SMIF
Notes: — : Unused bit.
*: The CKE1 bit must be cleared to 0 when the GM bit in SMR is cleared to 0.
SMR Setting: The GM bit is cleared to 0 in normal smart card interface mode, and set to 1 in
GSM mode. The O/E bit is cleared to 0 if the IC card is of the direct convention type, and set to 1
if of the inverse convention type.
Bits CKS1 and CKS0 select the clock source of the on-chip baud rate generator. Bits BCP1 and
BCP0 select the number of basic clock periods in a 1-bit transfer interval. For details, see section
17.3.5, Clock.
The BLK bit is cleared to 0 in normal smart card interface mode, and set to 1 in block transfer
mode.
BRR Setting: BRR is used to set the bit rate. See section 17.3.5, Clock, for the method of
calculating the value to be set.
SCR Setting: The function of the TIE, RIE, TE, and RE bits is the same as for the normal SCI.
For details, see section 16, Serial Communication Interface (SCI, IrDA).
Bits CKE1 and CKE0 specify the clock output. When the GM bit in SMR is cleared to 0, set these
bits to B'00 if a clock is not to be output, or to B'01 if a clock is to be output. When the GM bit in
SMR is set to 1, clock output is performed. The clock output can also be fixed high or low.