Datasheet

Section 18 I
2
C Bus Interface [Option]
(This function is not available in the H8S/2695)
R01UH0166EJ0600 Rev. 6.00 Page 897 of 1434
Mar 02, 2011
H8S/2633 Group, H8S/2633 F-ZTAT
TM
,
H8S/2633R F-ZTAT
TM
, H8S/2695
• Notes on IRIC Flag Clearance when Using Wait Function
If the SCL rise time exceeds the designated duration or if the slave device is of the type that
keeps SCL low and applies a wait state when the wait function is used in the master mode of
the I
2
C bus interface, read SCL and clear the IRIC flag after determining that SCL has gone
low, as shown below.
Clearing the IRIC flag to 0 when WAIT is set to 1 and SCL is being held at high level can
cause the SDA value to change before SCL goes low, resulting in a start condition or stop
condition being generated erroneously.
SCL
SCL = high duration
maintained
[1] Judgment that SCL = low [2] IRIC clearance
V
IH
SDA
IRIC
SCL = low detected
Figure 18.24 IRIC Flag Clearance in WAIT = 1 Status