Datasheet

Section 14 Timer Z

Rev. 3.00 Mar. 15, 2006 Page 241 of 526

REJ09B0060-0300

14.4.2 Waveform Output by Compare Match

Timer Z can perform 0, 1, or toggle output from the corresponding FTIOA, FTIOB, FTIOC, or

FTIOD output pin using compare match A, B, C, or D.

Figure 14.12 shows an example of the setting procedure for waveform output by compare match.

[1] Select 0 output, 1 output, or toggle output

as a compare much output, by means of

TIOR. The initial values set in TOCR are

output unit the first compare match occurs.

[2] Set the timing for compare match

generation in GRA/GRB/GRC/GRD.

[3] Enable or disable the timer output by TOER.

[4] Set the STR bit in TSTR to 1 to start the

TCNT count operation.

[1]

Output selection

Select waveform output mode

[2]

Set output timing

[3]

Enable waveform output

[4]

Start count operation

Figure 14.12 Example of Setting Procedure for Waveform Output by Compare Match