Datasheet

Section 6 Power-Down Modes
Rev. 4.00 Mar. 15, 2006 Page 85 of 556
REJ09B0026-0400
Standby mode is cleared by an interrupt. When an interrupt is requested, the system clock pulse
generator starts. After the time set in bits STS2 to STS0 in SYSCR1 has elapsed, and interrupt
exception handling starts. Standby mode is not cleared if the I bit of CCR is set to 1 or the
requested interrupt is disabled in the interrupt enable register.
When the RES pin goes low, the system clock pulse generator starts. Since system clock signals
are supplied to the entire chip as soon as the system clock pulse generator starts functioning, the
RES pin must be kept low until the pulse generator output stabilizes. After the pulse generator
output has stabilized, the CPU starts reset exception handling if the RES pin is driven high.
6.2.3 Subsleep Mode
In subsleep mode, operation of the CPU and on-chip peripheral modules is halted. As long as a
required voltage is applied, the contents of CPU registers, the on-chip RAM, and some registers of
the on-chip peripheral modules are retained. I/O ports keep the same states as before the transition.
Subsleep mode is cleared by an interrupt. When an interrupt is requested, subsleep mode is cleared
and interrupt exception handling starts. Subsleep mode is not cleared if the I bit of CCR is set to 1
or the requested interrupt is disabled in the interrupt enable register. After subsleep mode is
cleared, a transition is made to active mode when the LSON bit in SYSCR2 is 0, and a transition is
made to subactive mode when the bit is 1. After the time set in bits STS2 to STS0 in SYSCR1 has
elapsed, a transition is made to active mode.
When the RES pin goes low, the system clock pulse generator starts. Since system clock signals
are supplied to the entire chip as soon as the system clock pulse generator starts functioning, the
RES pin must be kept low until the pulse generator output stabilizes. After the pulse generator
output has stabilized, the CPU starts reset exception handling if the RES pin is driven high.
6.2.4 Subactive Mode
The operating frequency of subactive mode is selected from φ
W
/2, φ
W
/4, and φ
W
/8 by the SA1 and
SA0 bits in SYSCR2. After the SLEEP instruction is executed, the operating frequency changes to
the frequency which is set before the execution. When the SLEEP instruction is executed in
subactive mode, a transition to sleep mode, subsleep mode, standby mode, active mode, or
subactive mode is made, depending on the combination of SYSCR1 and SYSCR2. When the RES
pin goes low, the system clock pulse generator starts. Since system clock signals are supplied to
the entire chip as soon as the system clock pulse generator starts functioning, the RES pin must be
kept low until the pulse generator output stabilizes. After the pulse generator output has stabilized,
the CPU starts reset exception handling if the RES pin is driven high.