Datasheet

Section 16 Synchronous Serial Communication Unit (SSU)
Rev. 4.00 Mar. 15, 2006 Page 378 of 556
REJ09B0026-0400
16.5 Usage Note
When the output level of serial data is changed according to the values of the SOL and SOLP bit,
follow the procedures shown in figure 16.14.
Start
Clear the SOLP bit in SSCRH to 0.
Write the new value noted above
to the SOL bit.
Set the SOLP bit in SSCRH to 1.
Write the new value noted above
to the SOL bit.
End
Figure 16.14 Procedures when Changing Output Level of Serial Data