Datasheet

Section 12 Timer Z

Rev. 2.00 Sep. 23, 2005 Page 179 of 444

REJ09B0068-0200

12.4.2 Waveform Output by Compare Match

Timer Z can perform 0, 1, or toggle output from the corresponding FTIOA, FTIOB, FTIOC, or

FTIOD output pin using compare match A, B, C, or D.

Figure 12.12 shows an example of the setting procedure for waveform output by compare match.

[1] Select 0 output, 1 output, or toggle

output as a compare much output, by

means of TIOR. The initial values set in

TOCR are output unit the first compare

match occurs.

[2] Set the timing for compare match

generation in GRA/GRB/GRC/GRD.

[3] Enable or disable the timer output by

TOER.

[4] Set the STR bit in TSTR to 1 to start the

TCNT count operation.

[1]

Output selection

Select waveform output mode

[2]

Set output timing

[3]

Enable waveform output

[4]

Start count operation

Figure 12.12 Example of Setting Procedure for Waveform Output by Compare Match