Datasheet

Section 16 I
2
C Bus Interface 2 (IIC2)
Rev. 2.00 Sep. 23, 2005 Page 283 of 444
REJ09B0068-0200
Bit Bit Name
Initial
Value R/W Description
5
4
MST
TRS
0
0
R/W
R/W
Master/Slave Select
Transmit/Receive Select
In master mode with the I
2
C bus format, when
arbitration is lost, MST and TRS are both reset by
hardware, causing a transition to slave receive mode.
Modification of the TRS bit should be made between
transfer frames.
After data receive has been started in slave receive
mode, when the first seven bits of the receive data
agree with the slave address that is set to SAR and the
eighth bit is 1, TRS is automatically set to 1. If an
overrun error occurs in master mode with the clock
synchronous serial format, MST is cleared to 0 and
slave receive mode is entered.
Operating modes are described below according to
MST and TRS combination. When clocked synchronous
serial format is selected and MST is 1, clock is output.
00: Slave receive mode
01: Slave transmit mode
10: Master receive mode
11: Master transmit mode
3
2
1
0
CKS3
CKS2
CKS1
CKS0
0
0
0
0
R/W
R/W
R/W
R/W
Transfer Clock Select 3 to 0
These bits should be set according to the necessary
transfer rate in master mode. In slave mode, these bits
are used to secure the data setup time in transmit
mode. The time is 10 t
cyc
when CKS3 is 0, and 20 t
cyc
when CKS3 is 1. For details on transfer rate, see table
16.2.