Datasheet

Section 17 I
2
C Bus Interface 2 (IIC2)
Rev. 3.00 Sep. 10, 2007 Page 352 of 528
REJ09B0216-0300
TDRE
Data n
TEND
ICDRS
ICDRR
19 23456789
TRS
ICDRT
A
SCL
(Master output)
SDA
(Master output)
SDA
(Slave output)
SCL
(Slave output)
Bit 7
Slave transmit mode
Slave receive
mode
Bit 6 Bit 5 Bit 4 Bit 3 Bit 2 Bit 1 Bit 0
A
[3] Clear TEND
[5] Clear TDRE
[4] Read ICDRR (dummy read)
after clearing TRS
User
processing
Figure 17.10 Slave Transmit Mode Operation Timing (2)
17.4.5 Slave Receive Operation
In slave receive mode, the master device outputs the transmit clock and transmit data, and the
slave device returns an acknowledge signal. For slave receive mode operation timing, refer to
figures 17.11 and 17.12. The reception procedure and operations in slave receive mode are
described below.
1. Set the ICE bit in ICCR1 to 1. Set the MLS and WAIT bits in ICMR and the CKS3 to CKS0
bits in ICCR1 to 1. (Initial setting) Set the MST and TRS bits in ICCR1 to select slave receive
mode, and wait until the slave address matches.
2. When the slave address matches in the first frame following detection of the start condition,
the slave device outputs the level specified by ACKBT in ICIER to SDA, at the rise of the 9th
clock pulse. At the same time, RDRF in ICSR is set to read ICDRR (dummy read). (Since the
read data show the slave address and R/W, it is not used.)