Datasheet

Rev. 1.50 Sep. 18, 2007 Page vii of xxxiv
Notes:
When using an on-chip emulator (E7, E8) for H8/36109 program development and debugging, the
following restrictions must be noted.
1. The NMI pin is reserved for the E7 or E8, and cannot be used.
2. Pins P85, P86, and P87 cannot be used. In order to use these pins, additional hardware must be
provided on the user board.
3. Area H'01F000 to H'01FFFF is used by the E7 or E8, and is not available to the user.
4. Area H'F780 to H'FB7F must on no account be accessed.
5. When the E7 or E8 is used, address breaks can be set as either available to the user or for use
by the E7 or E8. If address breaks are set as being used by the E7 or E8, the address break
control registers must not be accessed.
6. When the E7 or E8 is used, NMI is an input/output pin (open-drain in output mode), P85 and
P87 are input pins, and P86 is an output pin.
7. Use channel 1 of the SCI3 (P21/RXD, P22/TXD) in on-board programming mode by boot
mode.
Related Manuals: The latest versions of all related manuals are available from our web site.
Please ensure you have the latest versions of all documents you require.
http://www.renesas.com/
H8/36109 Group manuals:
Document Title Document No.
H8/36109 Group Hardware Manual This manual
H8/300H Series Software Manual REJ09B0213
User's manuals for development tools:
Document Title Document No.
H8S, H8/300 Series C/C++ Compiler, Assembler, Optimizing Linkage Editor
User's Manual
REJ10B0058
H8S, H8/300 Series Simulator/Debugger User's Manual REJ10B0211
H8S, H8/300 Series High-Performance Embedded Workshop 3, Tutorial REJ10B0024
H8S, H8/300 Series High-Performance Embedded Workshop 3, User's
Manual
REJ10B0026