Datasheet

Section 17 Band-Gap Circuit, Power-On Reset, and Low-Voltage Detection Circuits
Rev. 3.00 Sep. 14, 2006 Page 286 of 408
REJ09B0105-0300
17.1 Features
• BGR circuit
Supplies stable reference voltage covering the entire operating voltage range and the operating
temperature range.
Reduces power consumption when BGR is disabled by setting registers.
• Power-on reset circuit
Uses an external capacitor to generate an internal reset signal when power is first supplied.
• Low-voltage detection circuit
LVDR: Monitors the power-supply voltage, and generates an internal reset signal when the
voltage falls below a given value.
LVDI: Monitors the power-supply voltage, and generates an interrupt when the voltage falls
below or rises above respective given values.
Two detection levels for reset generation voltage are available: when only the LVDR circuit is
used, or when the LVDI and LVDR circuits are both used.
[Legend]
Vcc: Power supply
BGRE: BGR circuit enable signal
VCL: Internal power supply generated from Vcc by the step-down circuit
VBGR: Reference voltage from BGR
VCLSEL: Select signal for the source of the on-chip oscillator power supply
RCSTP: On-chip oscillator stop signal
LVDE: LVD enable signal
Step-down circuit
On-chip
oscillator
LVD (low-voltage
detection circuit)
Vcc
VCL
VBGR
VCLSEL
RCSTP
LVDE
BGRE
BGR
Figure 17.1 Block Diagram around BGR