Datasheet

Section 20 Electrical Characteristics
Rev. 3.00 Sep. 14, 2006 Page 345 of 408
REJ09B0105-0300
20.3.8 Power-On Reset Characteristics
Table 20.20 Power-On Reset Circuit Characteristics
V
SS
= 0.0 V, T
a
= –20 to +75°C, unless otherwise indicated.
Values
Item Symbol
Test
Condition
Min. Typ. Max. Unit
Pull-up resistance of RES pin R
RES
100 150 — kΩ
Power-on reset start voltage* V
por
— — 100 mV
Note: * The power-supply voltage (Vcc) must fall below Vpor = 100 mV and then rise after
charge of the RES pin is removed completely. In order to remove charge of the RES
pin, it is recommended that the diode be placed in the Vcc side. If the power-supply
voltage (Vcc) rises from the point over 100 mV, a power-on reset may not occur.