Datasheet

Section 22 I
2
C Bus Interface 2 (IIC2)
Rev. 2.00 Jul. 04, 2007 Page 486 of 692
REJ09B0309-0200
Bit Bit Name
Initial
Value
R/W Description
4 SDAOP 1 R/W SDAO Write Protect
This bit controls change of output level of the SDA pin
by modifying the SDAO bit. To change the output level,
clear SDAO and SDAOP to 0 or set SDAO to 1 and
clear SDAOP to 0 by the MOV instruction. This bit is
always read as 1.
3 SCLO 1 R This bit monitors SCL output level. When SCLO is 1,
SCL pin outputs high. When SCLO is 0, SCL pin
outputs low.
2  1  Reserved
This bit is always read as 1.
1 IICRST 0 R/W IIC Control Part Reset
This bit resets the control part except for I
2
C registers. If
this bit is set to 1 when hang-up occurs because of
communication failure during I
2
C operation, I
2
C control
part can be reset without setting ports and initializing
registers.
0  1  Reserved
This bit is always read as 1.