Datasheet

Rev. 6.00 Aug 04, 2006 page viii of xxxvi
Item Page Revision (See Manual for Details)
8.15.1 The
Management of the
Un-Use Terminal
256 Description amended
• If an unused pin is an output pin, handle it in one of the
following ways:
 Set the output of the unused pin to high and pull it up to
V
CC with an external resistor of approximately 100 kΩ.
 Set the output of the unused pin to low and pull it down to
Vss with an external resistor of approximately 100 kΩ.
15.8.2 DC
Characteristics
Table 15.26 DC
Characteristics
519,
525
Table and notes amended
Item Symbol Applicable Pins
–I
p
Pull-up
MOS
current
P1
0
to P1
7
,
P2
4
*
6
,
P3
0
to P3
7
,
P5
0
to P5
7
,
P6
0
to P6
7
Notes:
4. Except current which flows to the pull-up MOS or output buffer
5. Voltage maintained in standby mode
6. Applies to the F-ZTAT version. The specified values for this pin
in reference values.
C.2 Block Diagrams
of Port 2
Figure C.2 (a-1)
Port 2 Block Diagram
(Pins P2
7
to P2
3
, Not
Including P2
4
in the F-
ZTAT Version of the
H8/38347 Group and
H8/38447 Group)
634 Figure title amended
Figure C.2 (a-2)
Port 2 Block Diagram
(Pin P2
4
in the F-ZTAT
Version of the
H8/38347 Group and
H8/38447 Group)
635 Newly added