Datasheet

Section 6 ROM
Rev. 6.00 Aug 04, 2006 page 171 of 680
REJ09B0145-0600
6.6 Descriptions of Registers of the Flash Memory
6.6.1 Flash Memory Control Register 1 (FLMCR1)
Bit 76543210
— SWE ESU PSU EV PV E P
Initial value00000000
Read/Write — R/W R/W R/W R/W R/W R/W R/W
FLMCR1 is a register that makes the flash memory change to program mode, program-verify
mode, erase mode, or erase-verify mode. For details on register setting, refer to section 6.8, Flash
Memory Programming/Erasing. By setting this register, the flash memory enters program mode,
erase mode, program-verify mode, or erase-verify mode. Read the data in the state that bits 6 to 0
of this register are cleared when using flash memory as normal built-in ROM.
Bit 7—Reserved
This bit is always read as 0 and cannot be modified.
Bit 6—Software Write Enable (SWE)
This bit is to set enabling/disabling of programming/enabling of flash memory (set when bits 5 to
0 and the EBR register are to be set).
Bit 6
SWE Description
0 Programming/erasing is disabled. Other FLMCR1 register bits and all EBR bits
cannot be set. (initial value)
1 Flash memory programming/erasing is enabled.