H8/3854 Series Expansion Board (HS3854EIO60H) for E6000 Emulator User’s Manual HS3854EIO60HE(B)
Cautions 1. Renesas neither warrants nor grants licenses of any rights of Renesas’s or any third party’s patent, copyright, trademark, or other intellectual property rights for information contained in this document. Renesas bears no responsibility for problems that may arise with third party’s rights, including intellectual property rights, in connection with use of the information contained in this document. 2. Products and product specifications may be subject to change without notice.
Preface Thank you for purchasing this H8/3854 series expansion board (HS3854EIO60H; hereinafter referred to as the expansion board) for the H8/300L series E6000 emulator. The expansion board enables user systems for Renesas's original microcomputer H8/3854 series to be developed using an H8/300L series E6000 emulator (HS3L08EPI60H; hereinafter referred to as the emulator) and the H8/3834 evaluation chip set (HS3834EVI60H).
Contents Section 1 Components ......................................................................................1 Section 2 Connection Procedures ......................................................................2 2.1 2.2 Using Emulator without Connecting User System ........................................................... 2 Using Emulator with Connecting User System through User System Interface Cable .... 2 Section 3 Reset Switch ............................................................
Section 1 Components Figure 1 shows the HS3854EIO60H expansion board appearance, and table 1 lists the components of the expansion board. Please make sure you have all of these components when unpacking. Figure 1 HS3854EIO60H Expansion Board Table 1 HS3854EIO60H Components No.
Section 2 Connection Procedures WARNING Always switch OFF the user system and the emulator product before the EXPANSION BOARD or USER SYSTEM INTERFACE CABLE is connected to or removed from any part. Before connecting, make sure that pin 1 on each side is correctly aligned. Failure to do so will result in a FIRE HAZARD and will damage the user system, the emulator product, the user system interface cable, and the expansion board, or will result in PERSONAL INJURY. The USER PROGRAM will be LOST. 2.
2. [1] After making sure the direction of the expansion board connector labeled E6000 EMULATOR is correct, firmly insert the expansion board connector into the emulator station connector ([1] in figure 2). [2] Connect the expansion board labeled USER INTERFACE CABLE and the user system interface cable body.
Section 3 Reset Switch The reset switch is on the side of the expansion board as shown in figure 2. Pressing the reset switch resets the H8/3854 dot-matrix LCD controller (table 2).
Section 4 Notice WARNING 1. This expansion board is specifically designed for the HS3L08EPI60H emulator and the HS3834EVI60H evaluation chip set. Do not use this expansion board with any other emulator station. 2. Use the H8/3854 series user system interface cable (HS3854ECH61H for FP-100B or HS3854ECN61H for TFP100G). Do not use any other series of user system interface cable. 1. Do not place heavy objects on the expansion board. 2. Power is supplied from the emulator station to the expansion board.
3. To open the case of the expansion board, remove the four screws on the top panel. To close the case, place the top panel on the expansion board, and fix it with the four screws. Screws 00 TOR ULA EM 6 E 0 0 0 E 60 Upper panel US ER IN E ABL EC FAC R TE Figure 3 Removing Expansion Board Upper Panel WARNING When using a polarized capacitor, make sure that the polarity is correct when installing the capacitor.
