Datasheet

Section 17 I
2
C Bus Interface 2 (IIC2)
Rev.5.00 Nov. 02, 2005 Page 334 of 500
REJ09B0027-0500
17.5 Interrupt Request
There are six interrupt requests in this module; transmit data empty, transmit end, receive data full,
NACK receive, STOP recognition, and arbitration lost/overrun error. Table 17.3 shows the
contents of each interrupt request.
Table 17.3 Interrupt Requests
Interrupt Request Abbreviation Interrupt Condition I
2
C Mode
Clocked
Synchronous Mode
Transmit Data Empty TXI (TDRE=1)
•
(TIE=1) { {
Transmit End TEI (TEND=1)
•
(TEIE=1) { {
Receive Data Full RXI (RDRF=1)
•
(RIE=1) { {
STOP Recognition STPI (STOP=1)
•
(STIE=1) { ×
NACK Receive { ×
Arbitration
Lost/Overrun Error
NAKI {(NACKF=1)+(AL=1)}
•
(NAKIE=1)
{ {
When interrupt conditions described in table 17.3 are 1 and the I bit in CCR is 0, the CPU
executes an interrupt exception processing. Interrupt sources should be cleared in the exception
processing. TDRE and TEND are automatically cleared to 0 by writing the transmit data to
ICDRT. RDRF are automatically cleared to 0 by reading ICDRR. TDRE is set to 1 again at the
same time when transmit data is written to ICDRT. When TDRE is cleared to 0, then an excessive
data of one byte may be transmitted.