User's Manual

REVISION HISTORY M16C/6N Group (M16C/6NK, M16C/6NM) Hardware Manual
Rev. Date
Description
Page Summary
C-5
258 Table 20.3 Unassigned Pin Handling in Memory Expansion Mode and Microprocessor
Mode (Normal-ver. only) is added.
259 Figure 20.12 Unassigned Pins Handling
• Figure of memory expansion mode or microprocessor mode is added.
• NOTES 1 and 3 are added.
260 Table 21.2 Flash Memory Rewrite Modes Overview
• Operation Mode of CPU Rewrite Mode is revised.
• NOTE 2 is revised.
• NOTE 4 is added.
261 21.1 Memory Map: 2nd sentence (The user ROM ...) is revised.
263 Figure 21.2 ROMCP Register is revised.
264 Table 21.3 EW0 Mode and EW1 Mode
• Flash Memory Status Detection of EW0 Mode is revised.
• NOTES 1and 2 are revised.
• NOTE 3 is added.
265 21.3.2 EW1 Mode: Last sentence (When an erase/program ...) is added.
267 21.3.3.4 FMSTP Bit
• 8th line: Procedure to change the FMSTP bit setting (1) to (4) are added.
269 Figure 21.5 Setting and Resetting of EW0 Mode
• First frame: “memory expansion mode” is added.
• NOTE 5 is revised and NOTE6 is added.
Figure 21.6 Setting and Resetting of EW1 Mode: NOTE 1 is revised.
270 Figure 21.7 Processing Before and After Low Power Dissipation Mode or On-chipOscillator
Low Power Dissipation Mode
• Title, First and second frames (left) and top of right: “on-chip oscillator low power
dissipation mode” is addded.
272 21.3.4.11 Stop Mode is revised.
21.3.4.12 Low Power Dissipation Mode and On-chip Oscillator Low Power Dissipation
Mode is partly revised.
275 21.3.5.5 Block Erase Command: Last sentence (Also execute ...) is added.
Figure 21.9 Block Erase Command: NOTES 2 and 3 are added.
281 Figure 21.12 Full Status Check and Handling Procedure for Each Error
• Erase error: (4) is added.
283 Table 21.7 Pin Functions for Standard Serial I/O Mode
• Description of VCC1, VCC2, VSS is revised.
• Description of P8_4 is revised.
• NOTE 1 is revised.
• NOTE 2 is added.
286 Figures 21.15 and 21.16 Circuit Application in Serial I/O Mode 1/2
• “VCC1” and “VCC2” are added.
288 Table 21.8 Pin Functions for CAN I/O Mode
• Description of VCC1, VCC2, VSS is revised.
• Description of P8_4 is revised.
• NOTE 1 is added.
2.00 Nov. 28, 2005