User's Manual

M306NKT3-RPD-E User’s Manual 2. Setup
REJ10J0326-0400 Rev.4.00 Sep. 01, 2006 Page 36 of 104
2.8.5 Connecting to a 100-pin 0.5mm pitch Foot Pattern (Part 1)
Figure 2.14 shows how to connect a 100-pin 0.5mm pitch foot pattern on the user system to the M3T-F160-100NSD (not
included), and here following is its procedure.
For details on the M3T-F160-100NSD (not included), refer to its user's manual.
(1) Attach the NQPACK100SD included with the M3T-F160-100NSD to the user system.
(2) Attach the YQPACK100SD included with M3T-F160-100NSD to the NQPACK100SD and secure it with the
YQ-GUIDE's.
(3) Attach the CN2 side of the M3T-F160-100NSD to the CN2 side of the package converter board connected to the emulation
pod probe.
(4) Attach the M3T-F160-100NSD to the YQPACK100SD.
Figure 2.14 Connecting to a 100-pin 0.5mm pitch foot pattern (1/2)
CAUTION
Note on Connecting the User System:
 Take care not to attach the converter board in a wrong direction. It may cause a fatal damage to the emulation
pod.
 The connectors of the M3T-F160-100NSD are guaranteed for only 50 insertion/removal iterations.
*
CN2 side
(3)
(1)
100-pin 0.5mm pitch
(PLQP0100KB-A) foot pattern
No. 1 pin
User system
M3T-F160-100NSD
(not included)
FLASH MCU, etc.
On-board evaluation
*: These four items are available in one package.
YQPACK100SD
NQPACK100SD
HQPACK100SD
(not included)
(2)
(4)
YQ-GUIDE (x4)
These corners are not round.
Package converter board
Tip of emulation pod probe