User's Manual

( 21 / 36 )
Figure 3.9 Pin layouts of the TQPACK032SA and M34513T-PTCC
TQPACK032SA
M34513T-PTCC
No. 1 pin
(Bevel edge)
No. 1 pin
(3) Connection to a 32-pin LQFP foot pattern
Attach pitch converter boards M34513T-PTCA and M34513T-PTCB to the included 50-wire
normal-pitch cable, and connect them to the TQPACK032SA soldered on a 32-pin LQFP foot
pattern of the target system via the M34513T-PTCC.
Use the following products:
(1) 100-wire half-pitch cable (40 cm)
(2) Pitch converter board PCA4029
(3) 50-wire normal-pitch cable (10 cm)
(4) Pitch converter board M34513T-PTCA
(5) Pitch converter board M34513T-PTCB
(6) Pitch converter board M34513T-PTCC (including TQPACK032SA)
Table 3.11 lists the pin assignments of the TQPACK032SA. Solder the TQPACK032SA on a 32-
pin LQFP foot pattern of the target system. Attach the M34513T-PTCC to the TQPACK032SA
matching the No. 1 pin positions (see Figure 3.9). Be careful not to connect them improperly.
Table 3.11 Pin assignments of the TQPACK032SA
*1: VDD is not used for inputting power from the target system, but it is used for outputting power
from the power circuit on the M34519T-MCU to the target system. Output of VDD (on/off) is set by
switch SW1. For details, refer to "3.3 Switches" (page 13).
*2: XIN is input from oscillator board OSC-2 on the M34519T-MCU, and it is not input from the
oscillator circuit on the target system. To change a system clock frequency, change the frequency of
oscillator board OSC-2.
Connector pin No. MCU pin No. Signal Connector pin No. MCU pin No. Signal
11D3 3232 D2
22D4 3131 D1
33D5 3030 D0
44D6/CNTR0 29 29 P13
55D7/CNTR1 28 28 P12
66P20/SCK 27 27 P11
77P21/SOUT 26 26 P10
88P22/SIN 25 25 P03
99RESET 24 24 P02
10 10 CNVSS 23 23 P01
11 11 XOUT 22 22 P00
12 12 XIN*
2
21 21 P63/AIN3
13 13 VSS 20 20 P62/AIN2
14 14 VDD*
1
19 19 P61/AIN1
15 15 VDCE 18 18 P60/AIN0
16 16 P30/INT0 17 17 P31/INT1