User's Manual

( 6 / 36 )
WARNING
Warning for Installation:
• Do not set this product in water or areas of high humidity. Spilling water or some other liquid into
the main unit can cause an unrepairable damage.
Warning for Use Environment:
• This equipment is to be used in an environment with a maximum ambient temperature of 35°C. Care
should be taken that this temperature is not exceeded.
CAUTION
Cautions to Be Taken for This Product:
• Do not disassemble or modify this product. Disassembling or modifying this product can cause
damage. Disassembling and modifying the product will void your warranty.
• Use caution when handling the main unit. Be careful not to apply a mechanical shock.
• Do not pull the emulator probe (100-wire half-pitch cable etc.) to disconnect from the emulator
main unit.
•Do not use inch-size screws for this equipment. The screws used in this equipment are all ISO
(meter-size) type screws. When replacing screws, use same type screws as equipped before.
IMPORTANT
Notes on Differences between Actual MCUs and the Emulator:
• Emulator operation differs from emulation of a mask MCU, as listed below. For details refer to
"Chapter 4. Precautions to Be Taken When Debugging a Program" (page 23).
(1) Reset condition
(2) Operation of the watchdog timer function
(3) Operation in RAM backup mode
(4) Port I/O timings and characteristics
(5) A-D conversion function
• Therefore, always be sure to evaluate your system with an evaluation MCU (OTP version). Also,
be sure to perform onboard evaluation with CS (Commercial Sample) version MCU to make final
confirmation of device operation before starting mask production.
Note on the Target System:
• Make sure that the target's supply voltage is + 3.0 V or + 5.0 V. Therefore the target's supply voltage
should be in the range of + 3.0 V ±10% or + 5.0 V ±10%.