User's Manual

( 7 / 36 )

Note on MCU board Installation:

• Before installing and removing the MCU board, always be sure to power off the PC4504 emulator

main unit and unplug its power cord from the outlet.

Note on Registers that Can be Operated from M3T-PD45

•The table below lists the registers that can be operated from M3T-PD45. The "Yes" in the table

means that the register can be operated; the "No" means that the register can not be operated.

IMPORTANT

Notes on Connecting the Target System:

• When connecting the target system, be sure to shut off the power of the emulator and the target

system.

• Connect the emulator probe carefully.

• When connecting the emulator probe, use care not to twist the cable. An excessive twist may cause

breaking of the wire.

PC Yes Yes W3 Yes Yes

CY Yes Yes W4 Yes Yes

A Yes Yes W5 Yes Yes

B Yes Yes W6 Yes Yes

D Yes Yes J1 Yes Yes

4518 and 4519 only

E Yes Yes Q1 Yes Yes

X Yes Yes Q2 Yes Yes

Y Yes Yes Q3 Yes Yes

Z Yes Yes K0 Yes Yes

V1 Yes Yes K1 Yes Yes

V2 Yes Yes K2 Yes Yes

I1 Yes Yes PU0 Yes Yes

I2 Yes Yes PU1 Yes Yes

MR Yes Yes FR0 No Yes

RG No Yes FR1 No Yes

PA No Yes FR2 No Yes

W1 Yes Yes FR3 No Yes

4518 and 4519 only

W2 Yes Yes SI Yes Yes

4518 and 4519 only